Advertisement
Strain
Relief
PJate
(not
sui
Figure 28
Figure 29
Casing
EmectdcalConnection
ELECTRICAL
CONNECTmON
EJectrical Shock Hazard
To avoid electrical
shock, do not work on an
energized
circuit. Doing so could result in serious
injury or death. OnJy quatified electricians
shouJd
perform electrical
work. Do not attempt any work
on the dishwasher
electric
supply circuit until you
are certain the circuit is de-energized.
Fire Hazard
To avoid a fire hazard, make sure eiectrica! work
is properly
installed.
Only qualified
eJectricians
shouJd perform eJectricaJ work.
Grounding
instructions
The dishwasher must be properly grounded before
operating, This appliance must be connected to a
grounded metal permanent wiring system, or an
equipment grounding conductor must be run with the
circuit conductors and connected to the equipment
grounding terminal or lead on the dishwasher, Make sure
that the dishwasher is connected to a suitable ground in
compliance with all local codes or, in the absence of a
local code, with the NATIONAL ELECTRICAL CODE in
the United States orthe CANADIAN ELECTRIC CODE
C22,1 -latest edition in Canada as well as any provincial/
state or municipal or local codes that apply,
1 Retrieve the strain relief plate, and install a strain relief
(not supplied) into the opening on the strain relief plate,
NOTE: Orient the strain relief as shown in Figure 28,
2 Pass the electrical supply cable through the strain
relief, as shown in Figure 29, Make sure the outer wire
casing extends about 1/2" (18mm) through the strain
relief,
3 Tighten the strain relief screws,
4 Slide the strain relief plate into the junction box, and
secure it to the junction box with the supplied screw,
13
Advertisement
