Advertisement
Enclosure
Preparation
23 9/16"
',598mm)
23-5/8"
- 24-1/4"
(600-616
mm
Figure 1
Check
_
......... -
E
E
E
E
clearance
E
between
dishwasher
,
I
door and wall
Countertop
Figure 2
i\
I\\
I
\
Electrical Shock Hazard
To avoid electrical
shock, make sure the water
suppJy and ebctrical
suppJy are shut off before
installation
or service.
ENCLOSURE
PREPARATmON
NOTE: This dishwasher is designed to be enclosed on the
top and both sides by standard residential kitchen
cabinetry.
Select a location as close to the sink as possible for
easy access to water supply and drain lines.
For proper dishwasher operation and appearance, ensure
that the enclosure is square and has the dimensions
shown in Figure !.
If the dishwasher is to be installed in a corner, make sure
that there is adequate clearance to open the door. See
Figure 2,
ElectricaJ Shock/Fire
Hazard
To avoid ebctric
shock or fire, do not allow the
eJectricaJ and water supply Jines to touch.
Separate channets are provided
under the
dishwasher
(see page 10}.
if the enclosure requires openings for the electrical supply
cable, hot water supply line, and dishwasher drain hose,
place them within the dimensions shown by the shaded
area of Figure 3 to avoid interference with the dishwasher
frame or other components, Make the openings for the
electrical supply cable and hot water supply line 1"
(25,4mm) diameter, Make the opening for the dishwasher
drain hose 1-1/4" (82mm) diameter, if the openings are
made through wood, sand them smooth, if the openings
are made through metal, make them large enough to
accommodate grommets or other protective sheaths with
inside diameters of 1" (25,4mm) for the electrical supply
cable and the hot water supply line, and 1-1/4" (32mm) for
the dishwasher drain hose,
Figure 3
4
Advertisement
