Advertisement
How to Install
This appliance should be installed in the ducted version only.
So it could not be installed in the recirculation version.
Before installing the hood, remove
2 brackets of the top cover by releasing
the screws. And refasten the screws
in the holes.
GB
Wall Drilling and Bracket Fixing
Draw a vertical line on the installing wall up to the ceiling, or as high as practical, at
the center of the area in which the hood will be installed.
Draw a horizontal line at the minimum distance of 600mm above the cook top.
Mark the centers of the 7 points shown below figure.
Drill ø 6mm holes at the centers marked.
Insert the 7 wall plugs into the holes.
Place the chimney bracket (a) coinciding the bracket holes with the upper 2 holes.
Secure the bracket using the screws provided. (M4 X L30)
Place the body fixing bracket (b) coinciding the bracket holes with the lower 3 holes.
Secure the bracket using the screws provided. (M4 X L30)
Product Bottom Line
Ceiling
(a)
220 mm
210 mm
130 mm
(b)
Cook top (Hob)
527 mm
Fig.1
6
21~22 mm
595 mm
Min. 450mm above Electric Hob.
(600mm is recommended
for better performance)
Advertisement
