Philips Fax Machine Manual page 29

You cannot phone or send faxes.
CHECK
DISPLAY
Error report
or
When you lift the receiver of your fax machine
you do not hear the dial tone.
or
fax transmissions are constantly interrupted.
You cannot send any faxes (you have set the
ringing signals with EXPERT mode).
Wrong dialling mode selected.
You are operating your fax machine on a private
branch exchange and have not set it accordingly.
The telephone connection is of poor quality.
The recipient has a paper jam or has run out of
paper.
Your fax partner's line is busy, does not answer
or a different device answers.
Improper installation or plug-in of fax machine. Check the installation of your fax machine.
You are connected to a PABX system.
You have connected your telephone cable to
the socket on the bottom of your fax machine
identified with EXT.
You have connected the telephone cable to the
socket marked with EXT.
Your fax correspondent has a fax machine that
cannot receive the usual standard identifying
signals.
You have set the total number of rings
(TOTAL RINGS: _) to a too high value. For
many fax machines, the call establishment
procedure is too long, and transmission is
interrupted.
Change the dialling mode with function 15.
In function 15, select PABX: Yes.
Try again or send the fax at reduced speed
(function 21).
Call your fax partner.
Try later or draw your fax partner's attention to
a possible installation fault.
Check the settings in function 15.
Connect your telephone cable to the socket on
the bottom of your fax machine identified with
LINE.
Plug the telephone cable into the socket
marked with LINE on the base of the fax
machine.
Try to send the fax manually: press DIAL/l
and dial the fax number. You will hear the call
being established. If the recipient is using an
automatic answering device, wait until you hear
a tone after the prerecorded message and then
press START.
Set the total rings or the toll free rings to a
lower value than 5 in function 31 or 32
FAX:EXPERT.