Sharp AN-WS350 Operation Manual page 5

Step 3
Place the Centre Bar next to the Metal Base, on top of the
Support Plate (G).
Step 4
From under the Metal Base, place 4 pieces of M8 [50mm]
screws (H) with Spring Washers Ø8 (O).
The screws should be tightened using Allen key M8 (Q)
according to the sequence A → B → C →D as shown
above.
Side view
Ensure that the specification label
is facing the floor when combining
the Centre Bar and Metal Base.
Step 5
Slowly lift the fixture upwards and let it stand on the
floor.
E-4