Cabling With Two Devices; Sas Devices; Scsi Devices; One Device Per Scsi Bus - HP StoreEver 1U User Manual

1u rack-mount enclosure

Hide thumbs Also See for StoreEver 1U:

Table of Contents

Figure 12 Attaching the cables

1. Power

2. Data

3. SCSI ID selector switch (SCSI drives only)

NOTE:

Replace the top access panel as shown.

Figure 13 Replacing the access panel

Cabling with Two Devices

The 1U rack-mount enclosure supports operation of two devices.

The 1U rack-mount enclosure supports operation of two SAS devices on two SAS buses. Two

internal SAS cables are installed in the enclosure, so completing the device installation is just a

matter of connecting each internal cable to a SAS device and cabling the external port to the

host. When connecting SAS devices to the internal cables, check to confirm that the SAS interface

in the enclosure supports the attached device. (For example, when connecting a tape drive device,

be sure to check that the SAS interface in the enclosure supports the attached tape drive.) The SAS

interface does not support daisy chaining. See also

The 1U rack-mount enclosure supports operation of two devices on either one or two SCSI buses.

Two internal 2-port SCSI cables are installed in the enclosure, so completing the device installation

is just a matter of connecting the correct SCSI port according to your configuration.

Use the configuration shown below when connecting each device to a separate SCSI bus.

Drive Installation

Fold excess cable length and secure with the clips provided in the enclosure.

SAS cabling recommendations (page

4).

Table of Contents

Storeever