Installation In Racks With 10-32 Threaded Holes - HP StoreEver 1U User Manual

1. Insert the pins in front mounting plate of the outer rack rails into the previously marked holes
in the front vertical mounting columns of the rack. The rack rails will lock securely into place.
Figure 18 Inserting the pins
NOTE:
of the rack rail and slide it forward (4).
2. Extend the rack rails past the rear vertical mounting column and insert the pins in the mounting
bracket into the previously marked holes in the rack. The rack rails will lock securely into place
when the end of the rails are pushed forward.
Figure 19 Locking the rack rails
NOTE:
of the rack rail and slide rearward (4).
Rail installation in a rack is complete. Continue with "Completing the installation"

Installation in Racks with 10-32 Threaded Holes

For installation in racks with 10-32 threaded holes in the vertical mounting columns the pins supplied
on the rails must be removed. The rails will be attached with user-supplied 10-32 x .375 screws.
To remove the rail for repositioning, push the spring-loaded tab (3) on the outside
To remove the rail for repositioning, push the spring-loaded tab (3) on the outside
Installing the 1U Rack-mount Enclosure in a Rack 15