Drive Installation; Tools Required; Drive Blank Removal And Installation - HP StoreEver 1U User Manual

2 Drive Installation

Tools Required

A 3/16" (5mm) flat-blade screwdriver or T- 1 5 Torx driver may be required to install a drive in the
1U rack-mount enclosure.

Drive Blank Removal and Installation

CAUTION:
and practice the procedures in
To install a tape or disk drive:
1. Remove the top access panel as shown.
Figure 7 Removing the access panel
2. Remove the drive blank:
a. Pull the spring-loaded button on the right mounting rail up.
b. Slide the assembly forward and then lift up.
Figure 8 Removing the drive blank
3. Remove the mounting brackets from the drive blank.
8 Drive Installation
To avoid damaging the equipment due to electrostatic discharge, be sure to review
Electrostatic discharge before handling the drives.