Rack Installation; Rail Mounting Kit; Tools Required; Installing The 1U Rack-Mount Enclosure In A Rack - HP StoreEver 1U User Manual

3 1U Rack Installation

Rail Mounting Kit

The rack rails supplied with the 1U rack-mount enclosure can be used to install the unit in racks
that have round, square, or threaded holes in the vertical mounting columns. The rails will fit racks
with 23 - 34 inches (58 - 86 cm) separation between the front and rear vertical mounting columns.
The rails are identical and may be mounted on either the left or the right side.
Figure 16 Rail mounting kit components
1. Outer rack rails
3. Cable support clips

Tools Required

If you are installing the 1U rack-mount enclosure in a rack with unmarked holes in the vertical
mounting columns the following items will make the rack installation easier:
Pencil
Tape measure
If you are installing the 1U rack-mount enclosure in a rack with threaded holes in the vertical
mounting columns you will need a 3/16" (5mm) flat-blade screwdriver.

Installing the 1U Rack-mount Enclosure in a Rack

Rack Safety

WARNING!
The rack leveling jacks are extended to the floor
The full weight of the rack rests on the leveling jacks
The stabilizing feet are attached to the rack
The racks are coupled in multiple rack installations
Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
To reduce the risk of personal injury or equipment damage, be sure that:
2. Inner component rails
4. Fasteners
Rail Mounting Kit 13