Php; Ahp; Utc - Motorola M12 Oncore User Manual

Position-Hold Position

php

Altitude-Hold Height

ahp

Time Mode

utc

Motorola GPS Products
M12 Oncore User' s Guide Supplement
Revision 1.0 01/25/00
COMMAND DESCRIPTIONS
Function Inputs the coordinates of the position to be
held by the Oncore receiver.
Syntax php (lat lon hgt g)
Example php 33 27 54.207 -111 54 08.444 350.000 g <ENTER>
Notes
See Also Position Control (@@Gd)
Binary Equivalent @@As
Function Sets the height for use with the altitude-hold feature.
Syntax ahp (hhhhh.hh g)
hhhhh.hh
g
Example ahp 350.98 g<ENTER>
Notes The height is specified in meters to a resolution of 0.01 m. The
altitude entered is referenced to the GPS height (height above the
reference ellipsoid being used).
See Also Position Control (@@Gd)
Binary Equivalent @@Au
Function References the time sent as part of the Position/Data/Message to
GPS or UTC time.
Syntax utc ([d | e])
d
e
Example utc e <ENTER>
Notes The satellite 1PPS output signal is referenced in the Oncore
receiver to UTC or GPS time based on this command.
See Also None
Binary Equivalent @@Aw
lat (–) dd mm ss.sss
lon (–) ddd mm ss.sss
hgt (–) mmmmm.mm
g GPS height
–1000.00 to 18,000.00 meters
GPS Height
disable (GPS time)
enable (UTC)
113