Time Mode - Motorola M12 Oncore User Manual

Motorola GPS Products
M12 Oncore User' s Guide Supplement
Revision 1.0 01/25/00

TIME MODE

This command selects the type of time (either GPS or UTC) to be output in the
Position/Status/Data and Short Position Messages. The Time Mode command will be used to
determine the synchronization point for the 1PPS timing pulse.
Note that if the receiver does not have the UTC parameters portion of the almanac, UTC will
be output as being equal to GPS time and a flag denoting the lack of UTC parameters will be
set in the Position/Status/Data message (@@Ha).
The receiver will have the UTC parameters once an almanac has been downloaded from the
satellites.
Default mode: UTC
28