Almin; Default - Motorola M12 Oncore User Manual

Almanac Data Input

almin

Set-To-Defaults

default

Motorola GPS Products
M12 Oncore User' s Guide Supplement
Revision 1.0 01/25/00
COMMAND DESCRIPTIONS
Function Manually enters an almanac data message into the Oncore
receiver.
Syntax almin (subframe page byte1, byte2..byte 34)
Example almin...............<ENTER>
Notes Inputs an almanac to the Oncore receiver. The almanac consists
of 34 subframe or page messages. A better method of inputting
an almanac is to use the run xxxxxxxx.alm command to output
an almanac stored in a receiver file by the Almanac Data Output
and Record GPS Data commands.
See Also Almanac Data Output (@@Be)
Record GPS Data (record)
Binary Equivalent @@Cb
Function Sets all the Oncore receiver parameters to the factory
default values.
Syntax default
Example default<ENTER>
Notes IMPORTANT: Upon executing this command, the current
almanac loaded in RAM is automatically deleted.
Before using this command, make sure you have made
backup copies (on a separate diskette) of your own
almanac file and/or the almanac file that was provided
with the receiver. The almanac must then be reloaded
after using the default command.
See Also None
Binary Equivalent @@Cf
119