Wiring Connections - Siemens Advance Network Gateway User Manual

Wiring Connections

Description
Figure 2-4. Power
Supply/ANCB Assembly
I/O Wiring
Figure 2-5. Wiring
Access Plate
Instructions
2000590-001
All input ac power and communications connections are made to con-
nectors located on the chassis power supply assembly. To gain access
to the assembly, open the front panel of the ANG_EN. For Zone 1 units
refer to the Figure 1-4, Zone 1 Outline Drawing.
Ethernet
Port
ANCB (Advance
Network
Communications
Board)
Two removable wiring access plates permit all the wiring to be made
through the bottom section (wall units) or rear section (rack units) of the
ANG_EN. The plates can be punched to accommodate conduit or cable
gland connectors. For Zone 1 units refer to the Figure 1-4, Zone 1 Out-
line Drawing.
ACCESS PLATES
AC Power (Mains) Connections
Data Hiway Cable Connections
Ethernet 10BaseT Connections
Advance Data
Hiway Port 1& 2
Page 18
Page 20
Page 23
AC Power
Power
ON/OFF
Switch
Installation 17