Siemens Advance Network Gateway User Manual page 32

Gateway with ethernet

Hide thumbs Also See for Advance Network Gateway:

Table of Contents

Ethernet Connections,

Installation

Continued

Do not perform the following procedure until you have defined the IP and

Subnetmask addresses; see Chapter 3. Data Communications Setup.

Step

Connect the incoming Ethernet line from the Hub to the

RJ-45 STP connector on the ANCB board.

Place the ANG_EN AC Power Supply (Mains) circuit

breaker to ON. On the ANG_EN Power Supply Assembly

place toggle ON/OFF switch to ON (Figure 2-4).

After the ANG_EN has been connected to a hub and both

the ANG_EN and hub have been powered on, verify the

connection by looking at the LEDs visible on the top card

edge of the ANCB; see page 49, ANCB LEDs Description

and Operation.

Action

RJ45 STP

Connector

2000590-001

Table of Contents

Troubleshooting