Switching Of Return Value Of Usb No./Support For Banding - Brother HL-4140CN Service Manual

2.7 Switching of Return Value of USB No./Support for
Banding
This function allows you to switch the return value of the USB No. and switch controls to
resolve banding symptoms.
<Operating procedure>
(1) Press the Go button and
"USB No." will appear on the LCD.
(2) Select one of the functions in the table below that you want to change the value using the
or
LCD
USBNo. =ON
PS.DitherType=0
DP.ImpGray=ON
Regi Freq
DX.XAdjust
DpSlp.StrDt
Special Printing
"*" is displayed at the end of the currently specified function in the LCD display.
(3) Select the value that you want to set using the
button.
(4) "Accepted" is displayed for approximately two second, and the printer goes back to the
ready state.
Note:
After the setting of USB No., turn OFF the power switch. (The change will not be
applied until the power switch is turned OFF and ON.)
button at the same time while the printer is in the ready state.
button and press the OK or Go button.
Changing return value of USB No.
Switching of PS Dither Pattern
Switching ON/OFF of DirectPrint Color mode-Improve Gray
Color
Switching of timing to execute Auto Registration
Adjusting left-end print start position on second side in duplex
printing
Switching ON/OFF of Deep Sleep function when StoreData
(Secure) exists
Change of the transfer current setting
(Only for Japanese hagaki printing)
Description
or button and press the OK or Go
5-65
Confidential