Output Terminal Configuration - Hitachi SJ300 Series Instruction Manual

Output Terminal
The inverter provides configuration for logic (discrete) and analog outputs, shown in the table
below.
Configuration
"C" Function
Func.
Name
Code
C021 Terminal [11] function *
C022 Terminal [12] function *
C023 Terminal [13] function *
C024 Terminal [14] function *
C025 Terminal [15] function
C026 Alarm relay terminal
function
C027 [FM] signal selection
C028 [AM] signal selection
C029 [AMI] signal selection
NOTE: *Terminals [11] – [13] or [11] – [14] are automatically configured as AC0 – AC2 or
AC0 – AC3 when C62 is configured to enable alarm code output.
The output logic convention is programmable for terminals [11] – [15], and the alarm relay
terminals. The open-collector output terminals [11] – [15] default to normally open (active
low), but you can select normally closed (active high) for the terminals in order to invert the
sense of the logic. You can invert the logical sense of the alarm relay output as well.
Run
Mode
Edit
Description
Lo Hi
✘ ✔
✘ ✔
✘ ✔
22 programmable
functions available
for logic (discrete)
✘ ✔
outputs (see next
section)
✘ ✔
✘ ✔
✘ ✔
8 programmable
✘ ✔
functions available
for analog outputs
(see after next
section)
✘ ✔
Defaults
Units
–FE –FU –FR
(EU) (US) (JP)
01 01 01
[FA1] [FA1] [FA1]
00 00 00
[RUN] [RUN] [RUN]
03 03 03
[OL] [OL] [OL]
07 07 07
[OTQ] [OTQ] [OTQ]
08 08 08
[IP] [IP] [IP]
05 05 05
[AL] [AL] [AL]
00 00 00
output output output
freq. freq. freq.
00 00 00
output output output
freq. freq. freq.
00 00 00
output output output
freq. freq. freq.
3–53
SJ300 Inverter
SRW Display
—
>C021 OUT-TM
11 FA1
— >C022 OUT-TM
12 RUN
— >C023 OUT-TM
13 OL
— >C024 OUT-TM
14 OTQ
— >C025 OUT-TM
15 IP
— >C026 OUT-TM
AL AL
— >C027 FM-MONITOR
KIND A-F
— >C028 AM-MONITOR
KIND A-F
— >C029 AMI-MON
KIND A-F