Checking And Adjusting Brake Wire; Checking And Adjusting Differential Lock - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Checking and adjusting brake wire

Check that the brake is correctly adjusted by
positioning the ride-on mower on a gentle slope
and applying the brake.
If the ride-on mower does not stand still, the brake
needs to be adjusted.
The brake is adjusted in the following way:
1. Remove the transmission cover.
2. Unhook the spring (A) from the screw (B).
3. Check that the parking brake is not applied.
4. Set a clearance of 1 mm between the casing
and adjusting screw when pulling the casing.
Adjust with the nuts on the adjusting screws.
5. Do not tighten the nuts too hard to avoid
damaging the adjusting screws.
6. Replace the spring (A).
7. Check that the brake functions.
8. Replace the transmission cover.
WARNING!
A badly adjusted brake can lead to
reduced braking capacity.
A
B
www.mymowerparts.com
Checking and adjusting differential
lock (ProFlex 21)
Check and adjust the differential lock (on the left-
hand side) as follows:
1. Make sure the differential lock is disengaged,
with the pedal fully raised.
2. Adjust so there is zero play between the outer
cable and the adjuster screw, using the two nuts
on the adjuster screw. You should not feel any
play when you pull the outer cable.
3. Tighten the nuts carefully to avoid damaging the
adjuster screw.
Reparation instructions
29
Svenska –