Replacing Hydrostatic Transmission Wire; Removal Of Hyrostatic Transmission Wire - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Replacing hydrostatic transmission wire

Removal of hydrostatic transmission wire
1
Remove the frame plate by undoing the screws
(two on each side).
2
Loosen the hydrostatic transmission's front lock nut
a 1/4 turn and remove the lock spring.
www.mymowerparts.com
3
Remove the hydrostatic transmission wire's front
clamp fixed inside the middle bracket.
4
Remove the transmission cover.
5
Follow the hydrostatic transmission wire backwards
towards the transmission and cut off the cable ties
round the wire.
6
Remove the locking spring at the rear linkage on
the hydrostatic transmission wire. Release the
clamp under the left drive shaft.
7
Lift off the linkage and pull out the wire.
Reparation instructions
39
Svenska –