Husqvarna Rider Pro 15 Workshop Manual page 33

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
5
Remove the inner circlip (1) from the lower bearing
(see diagram). The rear section is now loose and
can be moved. Then detach the outer circlip (2) and
take the bearing out downwards.
32
– Svenska
www.mymowerparts.com
6
• Take the upper bearing out upwards, if it does not
come out easily, it should be knocked out from
below.
• Insert the new bearings and assemble the
articulated steering in the reverse removal order.
• After re-assembly, the wire tension should be
checked (see "Checking and adjusting steering
wires"). Also check that the controls and wires
are correctly adjusted (see "Checking and
adjusting brake wire", "Checking and adjusting
speed control wire" and "Checking and adjusting
differential lock").
• Check the setting of the neutral position switch.