Removal/Installation Of Hydrostatic; Transmission - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Removing/installation of hydrostatic

transmission

1
• Block-up the machine in front of the rear frame
and remove the back wheels.
• Remove the transmission cover.
2
• Remove the nut (2), and lift off the washer and
fan from the input axle.
• Remove the oil tank and hose from the
hydrostatic transmission.
• Remove the disengaging control with its spring.
www.mymowerparts.com
3
4
2
• Disconnect the tensioning roller spring (1) and
prise off the drive belt.
• Release the speed control linkage (2) (on the
underside) and release the wire from underside
of the axle.
• Release the speed control linkage (on the
topside) from the hydrostatic transmission arm.
• Release the brake wire (3) spring and nuts. Prise
the wire off the brake arm.
4 Rider ProFlex 21
Disconnect the wire from the differential lock by
undoing the tensioning nuts (on upper bracket) and
freeing the wire from the differential arm.
5
Insert a garage jack under the hydrostatic transmis-
sion and loosen its five holder screws.
The rear retaining screw is placed in the front edge
of the bumper.
Reparation instructions
1
3
35
Svenska –