Using Multiples Handsets; Registering Handsets - Siemens Gigaset A580IP Manual

Using multiples handsets

Registering handsets

You can register up to six handsets to your base station.
When you register a new Gigaset handset, the base station transfers the Gigaset.net
entry for the Gigaset.net directory (
to use the Gigaset.net directory on your new handset.
Prerequisite: The handset can send and receive directory entries. See the handset's
user guide for further information.
Successful registration is acknowledged with the message Data Transfer x entries
rec for this reason.
Please note
u
If several handsets are registered on your base station, you can simultaneously
make two calls via the Internet and one via the fixed line network. Up to two
additional internal connections are also possible.
u
Selecting the connection via the Talk key (
handsets. This means that if you enter a number without a line suffix and with-
out defining a dialing plan for the phone number it will be dialed via the default
connection (
u
After registration, all the phone numbers for the phone will be assigned to the
handset as receive numbers. It will use the fixed line network number and the
first VoIP number in the configuration as send numbers.
For information on changing the assignments,
Registering another Gigaset A58H handset on the
Gigaset A580 IP
Before you can use your handset, you must register it to the base station.
You must initiate handset registration on the handset and on the base station.
The handset will return to idle status if registration was successful. The handset's
internal name is shown in the display, e.g. INT 1. If it does not appear, repeat the
procedure. Registration can take up to one minute.
¤
On the handset: Select
and press
¤
Enter the system PIN of the base station (the default is 0000) and press
Handset is registering flashes on the display.
¤
Within the next 60 seconds press and hold (for approx. 3 seconds) the
Registration/Paging key (
The handset is assigned the lowest available internal number (1-6). The internal
number appears in the display after registration, e.g. INT 2. This means that the
internal number 2 has been assigned to the handset.
£
Page 87).
¢
§Menu§
§OK§
.
£
Page
£
Page 48) to its local directory to enable you
£
Page 38) is not supported on GAP
£
Page
¢
Settings Handset
2) on the base station.
Using multiples handsets
122.
¢
Register Handset
§OK§
.
71