HP StorageWorks 1/8 User's And Service Manual page 152

Event code Description
83 Media attention
Tape drive tape alert; tape drive reported a
84
warning or critical tape alert.
85 DHCP request has failed
Autoclean media warning; not enough media
86
present to support autocleaning.
Drive not supported; the tape drive was
87 disabled because it cannot be used in this
Autoloader.
Drive firmware revision has not changed after
88
a tape drive firmware upgrade.
Invalid robotics code; does not match with
8C
the loaded Autoloader firmware.
Cleaning tape nearly expired. Only one or
8E
two cleaning operations remain.
2
8F
I C bus recovery
92 VPD data recovery.
External drive cooling fan failure (fan motion
has stopped). The subcode indicates which
drive sled fan is affected.
DB
Subcode 00: drive sled #1
Subcode 01: drive sled #2
etc.
F2 Drive sled missing.
152 Troubleshooting
Details and Solution
Evaluate media status using L&TT.
Evaluate drive status using L&TT.
• Check the network to ensure connection
to the DHCP server.
• Check that the network configuration is
correct.
• If DHCP is enabled, ensure that the DHCP
server is up and running on the device's
network.
• Power cycle the device and retry the op-
eration.
Insert a valid cleaning cartridge into the
Autoloader.
Replace the drive with a compatible tape
drive.
• Verify that the firmware image is correct
for the tape drive.
• Retry the operation.
• Retry using an alternate firmware upgrade
method.
Install new Autoloader firmware, which will
install a compatible robotics firmware
version.
Obtain a new cleaning tape for use when
the current cleaning tape expires.
Contact HP Service if this unexpected
condition occurs.
Power cycle the device and retry the
operation.
Verify that the fan for the indicated drive sled
is operational and not obstructed.
NOTE:
The fan only operates when cooling is
required.
• Power cycle the device and retry the op-
eration.
• Re-seat the tape drive to ensure a good
connection to the device.