Verifying The Installation; Configuring Additional Features - HP StorageWorks 1/8 User's And Service Manual

3. Remove one of the magazines from the Autoloader with the RMI or OCP:
• RMI: see
• OCP: see
Magazine)" on page 97
The Autoloader will not perform any other action while a magazine is out of the device.
4. Insert the tape cartridges into the magazine. (See Magazines" on page 47.)
5. Slide the magazine into the Autoloader.
6. Remove the other magazine, insert the tape cartridges, and replace the magazine.

Verifying the installation

Verify that the device has the current firmware revision.
To see the firmware revision on the front panel:
1. From the Home screen, press Next until the display shows Status/Information. Press Enter.
2. Press Next until the display shows Autoloader Information. Press Enter.
3. Press Next until the display shows the Firmware Rev.
To find the current firmware revision, visit the HP Support website: http://www.hp.com/support.
If necessary, update the device firmware:
• From the RMI, see
• From the OCP, see
FW Upgrade)" on page 103.
• Using HP Library and Tape Tools (L&TT), which can be downloaded free of charge from
www.hp.com/support/TapeTools.
After configuring the Autoloader, you can save the configuration settings to a USB flash drive from
the OCP or to a file from the RMI Configuration: Save/Restore screen. Having a backup of the
Autoloader configuration is helpful when recovering from a configuration error, setting up multiple
devices with similar configurations, or if the Autoloader needs service. See
device configuration and restoring factory

Configuring additional features

The Autoloader has many features to customize it for your organization.
• Enabling and configuring SNMP network management or Command View TL TapeAssure. See
Configuration: Network
• Setting up email event notification. See
• Naming the Autoloader, which is done from the RMI Configuration: Network screen. See
the network
• To use the RMI and OCP in Japanese, enable the Japanese language option through the RMI. See
Changing the system
42 Installing the Tape Autoloader
Releasing and replacing the
Unlocking, removing, and replacing magazines (Operations > Unlock Left or Right
Determining and updating firmware
Upgrading firmware (Support > Autoloader FW Upgrade, Support > Drive
Management" on page 67.
configuration, page 65.
configuration" on page 61.
magazines" on page 75.
" on page 77.
defaults, page 72.
Setting event notification
http://
Saving and restoring the
parameters" on page 72.
Changing