Changing Projector Settings - Fujitsu SCENICVIEW XP70 User Manual

If the energy-saving mode of the projector is not activated (DPMS enable deactivated), the
i
projector is still switched on, even if there is no signal, the present logo is displayed.
When the projector is switched to the energy-saving mode by the power management
system a power consumption of up to 11 W is maintained to feed the circuit for reswitching
the projector.
To completely switch off the power consumption, pull the plug of the projector power cable
out of the mains outlet. Remove the power plug only when the power indicated glows
orange!
Even when the projector is turned off, it is still connected to the power. Remove the plug
!
from the mains outlet so that the system is totally disconnected from the mains voltage.
Remove the power plug only when the power indicated glows orange!

Changing projector settings

Tilting the projector
With the projector foot (2 and 3) you can adjust the projector tilt within certain limits.
► Press the release button (1).
► Move the projector foot (2) into the desired position.
► Release the release button (1).
The projector foot is locked in the current position.
► Turn the projector foot (3) to change the inclination if necessary.
A26361-K954-Z100-1-5E19, edition 5
SCENICVIEW XP70
1
2
3
English - 13