HP 8517B Operating & Service Manual page 33

Figure 2-1
Table 2-1
(1) Power Cord U.S.A. only
(2) Test Set Interconnect Cable
(3) HP-IB Cable
(4) Specification and Performance Verification Software
(5) Anti-rotation Clamps
CAUTION
CAUTION
Accessories Supplied with the HP 8517B Test Set
Accessories in Figure 2-1
(6) Female 2.4 mm to Female 2.4 mm Adapter
(7) 20 mm, 98 N-cm (8 in-lb) Torque Wrench
(8) 1/2" x 9/16" Open End Wrench
(9) RF Source Cable, Bench-top Configuration
(10) RF Source Cable, Rack Configuration
Assemblies in the test set are extremely sensitive to damage by static
electricity. They may or may not continue to function if subjected to an
electrostatic discharge. Their reliability, however, will be impaired.
Always use an anti-static wrist strap when calibrating or verifying the test set
or while using the test set to measure devices. Never touch test port center
conductors. Use a wrist strap when connecting the extended center
conductor of a sliding load termination.
Initial Inspection
HP 8517B S-Parameter Test Set Manual 2-3
Installation