Connecting To The Ac Socket - Sharp HT-CN300H Operation Manual

Connecting to the AC socket

Plugging in the main unit
After all connections are made, plug in the unit.
Note:
Unplug the AC power lead from the wall socket if the unit will not be in use for a pro-
longed period of time.
Plugging in the remote control
Wall socket
(AC 230 V, 50 Hz)
Notes:
You can operate the remote control with batteries (not supplied) in areas where
the AC adaptor lead cannot reach (see page 16).
Remove the AC adaptor from the AC socket if the unit will not be in use for a pro-
longed period of time.
Use only the supplied AC adaptor. Another adaptor may cause an electric shock or
fire.
If it is necessary to replace the AC adaptor, replace it with the same type
(RADPA8005BGZZ) which is shown on page 3.
Demonstration mode
The first time the unit is plugged in, the unit will enter the demonstration mode. You
will see words scroll.
Wall socket
(AC 230 V, 50 Hz)
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode), press the X-
BASS button. The demonstration mode will be cancelled and the display will disap-
pear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS button again.
Note:
When the power is on, the X-BASS button can be used to select the extra bass mode
(see page 23).
To turn the power on
Press the ON/STAND-BY button on the main unit or the ON/ (STAND-BY) button on
To 3.6 V DC
the remote control.
input socket
To set the unit to stand-by mode:
Press the ON/STAND-BY button on the main unit or the ON/ (STAND-BY) button on
the remote control again.
Notes:
For the operation range and direction of the remote control, see page 16.
When turning on the power right after it is set to the stand-by mode, wait a few
seconds.
Power indicator
02/6/17 HT-CN300H_(E)3.fm
HT-CN300H
13