Display Control; Sound Control - Sharp HT-CN300H Operation Manual

Display control

To change the display brightness (2 levels)
You can switch the brightness of the main unit display by pressing the DIMMER but-
ton.
Dimmed (Dimmer mode)
TV screen display
By pressing the DISPLAY button whilst in the DVD or VIDEO mode, you can check
the status or setting on the TV screen.
Example: TV screen display
Caution:
This unit can display on the TV its current speaker and mode settings when in the
DVD or VIDEO mode, but not if connected to the TV via an S-video cable. This func-
tion is only available via the Video cable connection.

Sound control

Volume control
Press the VOLUME
decreasing.
Main unit
TV screen
Bass control
When the X-BASS button is pressed, the unit will enter the extra bass mode which
emphasises the bass frequencies. To cancel the extra bass mode, press the X-BASS
button.
Main unit
TV screen
Brightened
Equaliser
When the EQ button is pressed, the current mode setting will be displayed. To
change to a different mode, press the EQ button repeatedly until the desired sound
mode appears.
FLAT
ROCK
POPS
JAZZ
CLASSIC
VOCAL
Note:
Bass control and equaliser are enabled only when the sound mode is set to
"STEREO" or "VIRTUAL" (see page 26).
button to increase the volume and the VOLUME
.....
0 1 2 29 30 MAXIMUM
Bass frequencies are em-
phasised.
The sound is not modified.
Bass and treble are emphasised.
Bass and treble are slightly emphasised.
Treble is cut a little.
Treble is reduced a lot.
Vocals (midrange tones) are emphasised.
02/6/17 HT-CN300H_(E)4.fm
HT-CN300H
button for
Cancelled.
23