To Replace The Battery In The Remote Control - HP xp8010 series Reference Manual

Maintenance
6. Close the lid.
7. Turn on the projector. If the lamp does not turn on after the warm-up period, try
reinstalling the lamp again.
8. Open the on-screen menu and select setup > Reset lamp hours.
Å
WARNING: The lamp contains a small amount of mercury. If the lamp breaks, adequately
ventilate the area where the breakage occurred. Disposal of this lamp may be regulated due
to environmental considerations. For disposal or recycling information, please contact your
local authorities or the Electronic Industries Alliance (www.eiae.org).

To replace the battery in the remote control

1. Slide the remote control case open to reveal the battery compartment.
2. On the back of the remote control remove the battery cover
batteries.
3. Remove the old batteries, and install two new AAA batteries
4. Install the battery cover.
When discarding old batteries, contact your local waste-disposal provider regarding
local restrictions on the disposal or recycling of batteries.
70
1
to reveal the
2
.
Reference Guide