HP xp8010 series Reference Manual page 80

Troubleshooting
If you forget the projector's web administrator password:
If you can access the projector via the web, but only the home page:
If the network configuration is completely wrong and you cannot fix it:
80
set for the projector—contact the network administrator for a
valid TCP/IP network configuration, then set up the projector
accordingly.
❏
Reset the projector's network configuration to the factory-default
values. To do this, turn off the projector. Then insert a
straightened paperclip into the small hole in the connectivity
module panel. While pressing the small button inside, turn the
main disconnect switch off and on and continue holding the
button for at least 15 seconds.
❏
The web interface has been protected by the web administrator.
Contact the administrator.
❏
Reset the projector's network configuration to the factory-default
values. To do this, turn off the projector. Then insert a
straightened paperclip into the small hole in the connectivity
module panel. While pressing the small button inside, turn the
main disconnect switch off and on and continue holding the
button for at least 15 seconds.
Reference Guide