Setting Sonet Receive Interface - HP OMNIBER 718 37718A User Manual

Description
TIP:
HOW TO:
Setting the Interfaces

Setting SONET Receive Interface

Setting SONET Receive Interface
SONET Receive interface settings should match the network equipment
settings of Rate and Mapping, and determine the payload to be tested.
If you wish to set the HP 37718A transmitter and receiver to the same
interface settings, choose
1 Choose the required SIGNAL source.
If STS-1 or STS-3 is chosen, choose the required LEVEL.
If the LEVEL chosen is
2 Choose mapping and type of payload.
3 If VT-6 mapping is chosen, and CONCATENATION is enabled, choose
the tributary at which the concatenation begins.
If VT-6, VT-2 or VT-1.5 mapping is chosen, choose the test tributary
under CHANNEL.
4 Choose the payload framing under PAYLOAD TYPE or VT PAYLOAD.
If
STRUCTURED
If
STRUCTURED
"Setting Receive Structured Payload/Test Signal" page 39.
If DROP is chosen, see "Dropping an External Payload/Test Signal"
page 46.
5 Choose the PATTERN type and PRBS polarity.
OTHER
SETTINGS CONTROL COUPLED
choose the required GAIN.
MONITOR
is required
FRAMED
is chosen the Payload test signal must be set up. See
must be chosen.
.
17