Resetting The Timer Memory; To Reset The Permanent Memory; To Clear The Memory - Toro ECx User Manual

Resetting The Timer Memory

The ECx program memory can be reset to the perma-
nent program values or cleared completely at any time
without removing power.
Resetting the permanent program erases all user input
and replaces it with the permanent program values.
Clearing the program memory sets all program values to
Off (i.e., no active days, program start times or zone run
times). You may find that this simplifies programming the
timer if your watering requirements are quite different
than the permanent values.
Note: When power is first applied, the ECx will always
reset to the permanent program values.
To Reset The Permanent Program (Figure 3)
1 Turn the control dial to the
displayed.
2 Press the +/ and –/
ON
until CLR is displayed.
3 Return the control dial to the
To Clear The Memory (Figure 4)
1 Turn the control dial to the
displayed.
2 Press the +/ and –/
ON
until CLR 0 is displayed.
3 Return the control dial to the
position. OFF will be
OFF
buttons at the same time
OFF
/ position.
AUTO ON
position. OFF will be
OFF
buttons at the same time
OFF
/ position.
AUTO ON
Figure 3
2
3
AUTO / ON
RAIN SET TIME / DAY
DELAY
1
SET
OFF
WATERING
DAYS
SET
SEASON PROGRAM
START
ADJUST
SET ZONE
TIMES
RUN TIMES
Figure 4
2
3
AUTO / ON
RAIN SET TIME / DAY
DELAY
1
SET
OFF
WATERING
DAYS
SET
SEASON PROGRAM
ADJUST START
SET ZONE TIMES
RUN TIMES
ON
2
MANUAL
NEXT
START
OFF
PROGRAMS
2
ON
MANUAL
NEXT
START
OFF
PROGRAMS
15