Watering Control Features; To Pause Watering; To Resume Watering; To Cancel Watering - Toro ECx User Manual

Watering Control Features

The following watering control features enable you to fur-
ther control the watering program during operation.
All watering control features apply to watering programs
started manually and automatically.

To Pause Watering

Press the +/ and –/
ON
• The zone currently watering will shut off.
• The "Watering On" symbol will begin flashing.
• The display will show the amount of run time remain-
ing for the paused zone.
Note: If watering is not resumed within 8 minutes, all
watering operations will be canceled and the timer will
return to the automatic mode.
To Resume Watering (when paused)
Press the button.
NEXT
• Watering activity will resume from the point of inter-
ruption.
28
buttons at the same time.
OFF

To Cancel Watering

Press the +/ and –/
ON OFF
two times.
• All watering operations will be canceled and the timer
will return to the automatic mode.
Note: Placing the control dial in the OFF position for
two seconds, then back to
all watering operations.

To Skip Zones

Press the button one time.
NEXT
• The zone currently watering will shut off and the next
zone will start.
• If the last zone is skipped, the program will end. If
additional programs have been set to operate the
next program in alphabetical order will start.
To Adjust The Zone Run Time
Press the +/ button to increase run time or the –/
ON
button to decrease run time.
• If the zone run time is decreased to less than 1
minute, the zone will shut off. The next zone in
sequence will start.
• The zone run time is changed during this operation
only. The program memory will not be changed.
buttons at the same time -
/ will also cancel
AUTO ON
OFF