Firmware Management; Enable Debug Messages; Set/Change Password; Restore Factory Defaults - Dell Server Console Switch User Manual

Firmware Management

This menu contains the Flash Download selection. For more information, see
"Tools - Rebooting and Upgrading" on page 65.

Enable Debug Messages

This menu option turns on console status messages. Because this can
significantly reduce performance, only enable debug messages when instructed to
do so by Technical Support. When you are finished viewing the messages, press
any key to exit this mode.

Set/Change Password

This menu option allows enabling and disabling of serial port security, which
locks the serial port with a user-defined password.

Restore Factory Defaults

This menu option will restore all switch options to the default settings.

Reset Switch

This menu option allows you to execute a soft reset of the SCS.

Set Web Interface Ports

The SCS uses ports 80 and 443 for HTTP and HTTPS port numbers,
respectively. The user can modify or specify alternate ports.
NOTE: A reboot of the SCS is required to use new port numbers.

Exit

This menu selection will return you to the ready prompt. If the Console menu
interface password is enabled, you must exit the Console Main menu so that the
next user will be prompted with the Password login screen.
xxx | xxx
107
Terminal Operation