Table of Contents
Advertisement
To configure general network settings:
1
Click the Network tab, then click the General tab to display the SCS
General Network Settings screen.
2
Select one of the following options from the LAN Speed drop-down menu:
Auto-Detect, 10 Mbps Half Duplex, 10 Mbps Full Duplex, 100 Mbps Half
Duplex, or 100 Mbps Full Duplex.
NOTE: You must reboot if you change the Ethernet mode.
3
Select either Enabled or Disabled in the ICMP Ping Reply drop-down
menu.
4
Verify or modify the HTTP or HTTPS ports. The settings will default to
HTTP 80 and HTTPS 443.
5
Click Save.
To configure IPv4 network settings:
1
Click the Network tab, then click the Address tab to display the IPv4
Settings screen.
2
Click the IPv4 button.
3
Click to fill or clear the Enable IPv4 checkbox.
4
Enter the desired information in the Address, Subnet, and Gateway fields.
IPv4 addresses are entered as the xxx.xxx.xxx.xxx dot notation.
5
Select either Enabled or Disabled from the DHCP drop-down menu.
NOTE: If you enable DHCP, any information that you enter in the Address, Subnet, and
Gateway fields will be ignored.
6
Click Save.
To configure IPv6 network settings:
1
Click the IPv6 button.
xxx
OBWI Operation
|
xxx
69
Advertisement
Table of Contents
