Table 3-2 Sv8100 Maximum System Capacities - Blades - NEC UNIVERGE SV8100 Configuration Manual

UNIVERGE SV8100
Table 3-2 SV8100 Maximum System Capacities – Blades
number for each blade that can be installed in a system.
These are determined by the maximum blade configuration allowed. When installing
single line sets, DISA, or tie lines, CPU circuits must be allocated for DTMF receivers.
To install single line sets with CO/PBX line access, or when installing immediate-start
tie lines, CPU circuits must be allocated for dial tone detection.
Number of Slot(s) for Interface
Common Control Blades:
CD-CP00
PZ-32IPLA
(32-port VoIP Daughter Board)
PZ-64IPLA
(64-port VoIP Daughter Board)
PZ-128IPLA
(128-port VoIP Daughter Board)
PZ-ME50
(Memory Expansion Daughter
Board)
PZ-VM21
(Voice Mail Daughter Board)
Station Blades:
CD-4DIOPB
(4 DID/OPX)
CD-4LCA
(4 Single Line Telephone
Interface)
CD-8LCA
(8 Single Line Telephone
Interface)
CD-8DLCA
(8 Digital Station Interface)
Configuration Guide
Table 3-2 SV8100 Maximum System Capacities – Blades
Hardware
Package
19"
9.5" Chassis
Chassis
Chassis without
with CPU
3 Slots 5 Slots
1 1
1 1
1 1
1 1
1 1
1 1
2 5
2 5
2 5
2 5
shows the maximum
19"
19"
Chassis
x4
CPU
6 Slots 23 Slots
0 1
0 1 This unit provides
32 VOIP Gateway
0 1 This unit provides
64 VOIP Gateway
0 1 This unit provides
128 VOIP Gateway
0 1
0 1
6 23 When installed as
6 23
6 23
6 23
Issue 2.00
Comments
–
channels
channels
channels
–
Does include
modem
an OPX blade
–
–
–
3 - 3