Table of Contents
Advertisement
OPERATING INSTRUCTIONS (continued)
2 Pictures (Split)
Input terminal
NOTE
• Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not
change to power save mode.
• Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.
Input Signal Screen Display
The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control or
the monitor.
The display will go out in approximately 6 seconds.
Downloaded from
www.Manualslib.com
RECALL button
VOL
PinP button
RGB 1
RGB 2
MUTE
VOL
AV1
AV2
AV3
AV4
AUTO
PinP
SIZE
RECALL
MENU
OK
ID
ID SET
AV1 AV4
PAL
NTSC3.58
Sub
Main
SECAM
NTSC4.43
PAL, SECAM
AV1
AV4
NTSC3.58/4.43
576i, 576p
480i, 480p
AV1
1080i/50
AV2
1080i/60
720p/60
RGB1
STB
RGB2
Component
manuals search engine
Displaying MULTI PICTURE
If the PinP button on the remote control is pressed MULTI
PICTURE will display.
Activating the P-in-P mode from the RGB input screen
Pressing the PinP button one time will display 2 pictures.
• This mode can be available from RGB1(DVI-PC) and RGB2(RGB)
input.
• The speaker icon can be shifted left and right by pressing the
and
SELECT buttons; the audio of the video will be output from
the side on which the speaker icon is located.
• The sub-screen position can be
selected up and down by pressing
SELECT buttons.
• The sub-screen can be selected with
the AV1, AV2, AV3, and AV4 buttons
from the status that the speaker icon
appears on the left side of AV
shown in the diagram to the right.
• Pressing the PinP button again or
the RETURN button will cancel the 2 pictures display.
• "Frequency Mode" in the Setup Menu should be set to Movie when
RECALL button
sub-screen is the component signal of 1080i/50 or 1080i/60.
Activating the Split mode from the video input screen
Pressing the PinP button one
time will display 2 pictures.
• The speaker icon can be shifted left
RETURN button
and right by pressing the
SELECT buttons; the audio of the
video will be output from the side on
which the speaker icon is located.
• The same video input mode cannot
be selected for both screens at the
same time.
• Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
• When the Video input is set to RGB Video, this Split mode is not possible.
• Refer to the table for 2 pictures (Split) mode.
AV1, AV2
576i
480i
1080i/50
1080i/60 720p/60
576p
480p
VIDEO
Off-timer
On-timer
RGB2
AV1
✱
as
AV1: Displays the VIDEO input signal of the sub-screen.
AV1
and
RGB1
RGB2
STB
Component
Main
Sub
(
Input mode
AV1
Signal mode
Composite
-- -- Min.
OFF
-- -- : -- --
(Sub-
screen)
AV2
Advertisement
Table of Contents
