Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Connecting Antenna
Make sure that the power switch of the monitor is turned off.
When the "ANT" terminal is connected to outdoor antenna instead of CATV system, please note that a good
antenna adaptor is necessary. See the diagram on the right.
Precautions when connecting the antenna
• Clamp section A using pliers when installing the coaxial cable. If other types of adaptors are used, be sure
• Please use a coaxial cable which is free from interference to connect the antenna. Avoid using a parallel flat
• Avoid using indoor antenna as this may be affected by interference. Please use CATV net or outdoor
• Keep the power cord as far away from the antenna wire as possible.
• For safety, install an external antenna conforming to AS1417.1 (applicable for Australia only)
If there are noise appearance in the picture of VHF-Low band channel, please use the double-shielded cable (not
provided) for RF LEADS to reduce the noise.
Downloaded from
www.Manualslib.com
Speaker (R)
antenna
that the core and shielding are good.
feeder wire as interference may occur, causing reception to be unstable and stripe noise to appear on the
screen.
antenna.
manuals search engine
Monitor rear panel
20 18
16
14
12
10
8
6
4
2
21 19
17
15
13
11
9
7
5
3
1
Speaker (L)
Advertisement
Table of Contents
