Husqvarna Rider Pro 18 AWD Operator's Manual page 62

Changing the Engine Oil
The engine oil should be changed the first time
after 8 hours running time. It should then be
changed after every 100 hours of running time.
When operating with a heavy load or at high
ambient temperatures, replace every 50 hours.
WARNING!
Engine oil can be very hot if it is
drained directly after stopping
the engine. Allow the engine to
cool somewhat first.
1. Open the engine cover.
2. Place a container underneath the engine's left
oil drain plug.
3. Remove the dipstick. Remove the drain plug
from the engine's left side.
4. Let the oil run out into the container.
5. Then replace the oil drain plug and tighten it.
6. Replace the oil filter if necessary.
7. Fill with oil up to the FULL mark on the dipstick.
Use engine oil as set out above.
8. Run the engine warm, then check that there is
no leakage from the oil plug.
9. Check the oil level. Top up if necessary.
9. Hydrostatic Cable with Linkage
Remove the transmission cover, two screws.
Lubricate the joints and bearings on the left side
with an oilcan.
Remove the rubber casing and lubricate the
hydrostatic transmission cable with an oil can.
Press the pedal a few times and lubricate again.
Replace the rubber cover.
Replace the transmission cover.
60
– English
LUBRICATION
IMPORTANT INFORMATION
Used engine oil is a health hazard and must
not be disposed of on the ground or in
nature; it should always be disposed of at a
workshop or appropriate disposal location.
Avoid skin contact; wash with soap and
water in case of spills.
8009-529
6008-209
6020-024