Inspecting The Transmission Oil Level - Yamaha TZR50 '03 Service Manual

Table of Contents

Advertisement

INSPECTING THE OIL LEVEL OF THE TRANSMIS-
SION/CHANGING THE TRANSMISSION OIL
INSPECTING THE OIL LEVEL OF THE
TRANSMISSION
1. Heat up the engine for one minute and
then stop this
2. Keep the motorcycle horizontal and take
out the level screw
3. Inspect:
• The oil level
The oil level must be enough to overflow
when taking out the level screw
Oil level too low
oil to re-establish the right level.
Recommended oil:
SAE 10W 30 SE type engine oil.
CAUTION
• Do not add chemical additives. The trans-
mission oil also lubricates the clutch and
the additives could make it slip.
• Make sure that no foreign bodies get into
the crankcase.
CHANGING THE TRANSMISSION OIL
1. Warm up the engine for a few minutes.
2. Place an open recipient under the engine
3. Remove:
• The oil filler cap
• Oil drain plug
4. Empty:
• The transmission oil
NOTE:
Empty out the transmission oil when the
motorcycle is completely vertical.
3-10
INSP
ADJ
top up with sufficient

Advertisement

Table of Contents
loading

This manual is also suitable for:

X-power '03 5wx-ae12003 tzr502003 x-power

Table of Contents