Powering Off - Fujitsu ETERNUS DX100 S3 Operation Manual

Chapter 2 Basic Operation
2.1 Powering On and Off
1
Press the Power switch of the controller enclosure.
Power switch
The POWER LEDs on the controller enclosure and the drive enclosures are turned on.
2
After approximately two minutes (after approximately six minutes in a Unified configuration), check
that the READY LED of the controller enclosure is lit up.
2.1.4

Powering Off

To turn off the ETERNUS DX, perform one of the procedures below.
Via power switch
•
Press the Power switch to turn off the ETERNUS DX.
Via ETERNUS Web GUI or ETERNUS CLI
•
Use ETERNUS Web GUI or ETERNUS CLI to turn off the ETERNUS DX.
The following methods can be used to turn off the power by linking with the server.
Via the power synchronized unit
•
Use the power synchronized unit to turn off the ETERNUS DX.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Controller enclosure
Drive enclosure
Controller enclosure
49
Copyright 2014 FUJITSU LIMITED
P3AM-7662-04ENZ0