NEC RT50X User Manual page 17

Rear terminal panel
7
ON MAIN POWER OFF
AC IN
16
7 MAIN POWER ON/OFF Switch
Turns the main power on or off to the rear projection display.
Press the "|" side of the switch to turn on the main power and "O" to turn
off the main power.
8 RGB INPUT (R/Cr/Pr, G/Y, B/Cb/Pb, H/HV, V ) Connectors (BNC)
Connect R,G,B,H (Horizontal sync) and V (Vertical sync) outputs of the
external equipment. If using the equipment with a composite sync
(SYNC) output, connect it to the H/V terminal. Also connect component
video outputs (Y/Cb/Cr) of the equipment such as a DVD player.
9 AUDIO Input Jacks (RCA)
Connect an audio output of the equipment connected to 8 [RGB IN-
PUT] connector. For monaural audio, connect it to L/MONO.
10 S-VIDEO Input Connector (Mini DIN 4 pin)
Connect an S-Video output of a video equipment such as VCR.
11 VIDEO Input Connector (RCA)
Connect a video output of a video equipment such as VCR.
12 AUDIO Input Jacks (RCA)
Connect an audio output of the video equipment connected to S-VIDEO
or VIDEO INPUT .
For monaural audio, connect it to L/MONO.
13 REMOTE CONTROL Input Mini Jack
Connect your remote control cable here for wired operation.
Be sure to pull out the remote control cable from here for wireless op-
eration.
Inserting the remote control cable here disables the wireless remote
control operation.
14 PC CONTROL Port (Mini D- Sub 9 pin)
Use this port to connect your PC to control your rear projection display.
This enables you to use your PC and serial communication protocol to
control the rear projection display. If you are writing your own program,
typical PC control codes are on page E-44.
RGB INPUT
R/Cr/Pr G/Y B/Cb/Pb H/HV
8
E – 11
S-VIDEO VIDEO
AUDIO AUDIO
L/MONO L/MONO
V
R R
9 10 11 12 13
15 MOUSE OUTPUT Port (Mini DIN 8 pin)
Use this port to operate your computer's mouse functions from the re-
mote control.
16 AC Input
Connect the supplied power cable's three –pin glug here.
Plug the other end into an active wall outlet.
MOUSE
REMOTE
OUTPUT
PC CONTROL
CONTROL
14 15