Table of Contents
Advertisement
WARNING
Attaching the supplied chains to prevent against overturning
To prevent the rear projection display from overturning, be sure to install it on a level surface and fix it to a wall or pillar using the supplied chains.
To attach the supplied chains to the wall or pillar:
Be sure to use the two chains.
1. Fix one end of the chain to the wall or pillar.
NOTE: The chains, wall or pillar must withstand a force of 30 kg/66 lbs.
2. Put the other end of the chain on a round screw hook of the rear panel. Do this for both round screw hooks.
NOTE: Make sure that the chains are kept taut. Slack in the chains may cause the rear projection display to overturn resulting in injury.
250 mm/10"
The distance between the hook head and the wall
should be 250 mm/10 in. or less.
NOTE: Use commercially available M4 type round screw hooks on
a wall or pillar.The hooks must withstand a force of 30 kg/66 lb.
Do's and Don'ts
Take up slack in the chains
Use these two round screw hooks on the rear panel.
Keep chains straight
E – 19
Advertisement
Table of Contents
