Table of Contents
Advertisement
[Video &S-Video System Select]
This feature enables you to select composite video standards manually.
Normally select "Auto".
When you select the video standard for Video and S-Video separately,
first select the radio button and then select the video standard from the
pull-down menu.
This must be done for Video and S-Video respectively.
[Page 3] (Advanced mode)
Auto Start
Turns the rear projection display on automatically when the power cable
is inserted into an active power outlet and the main power switch is On.
This eliminates the need to always use the "Power" button on the re-
mote control or cabinet.
Power Management
When this option is on and there is no RGB input for five minutes or
more, the rear projection display will automatically turn itself off.
NOTE: This feature does not work with Video or S-Video sources.
Power Off Confirmation
This option determines whether a confirmation dialog for turning off the
rear projection display will appear or not.
Clear Lamp Hour Meter
Resets the lamp clock back to zero. Pressing this button displays the
"Are you sure?" confirmation dialog box. To reset the lamp usage hour
meter, press "OK".
NOTE: The rear projection display will turn off and go into standby mode after
2100 hours (up to 3150 hours in Eco mode) of service. If this happens, press
the "Help" button on the remote control for ten seconds to reset the lamp clock
back to zero. Do this only after replacing the lamp.
Help
Contents
Provides an online help about how to use the menus. An underlined link
means that you can move to an adjustment item directly. Selecting the
underlined link and pressing ENTER moves to the corresponding ad-
justment item.
Information
Displays the status of the current signal and lamp usage. This dialog
box has four pages. The information included are as follows:
[Page 2]
[Page 3]
Signal Type
Aspect Ratio
Video Type
Gamma Correction
Sync Type
Noise Reduction
Interlace
Color Matrix
Resolution
Matrix Type
NOTE: The progress indicator shows the percentage of remaining bulb life.The
value informs you of the amount of lamp and projector usage respectively.
E – 35
[Page 4]
Remaining Lamp Time (%)
Lamp Hour Meter (H)
Projector Usage
Advertisement
Table of Contents
