Electrical Connection - Miele MM 50-175 Operating Instructions Manual

Notes for the installer
Levelling and securing the ironer
Use a spirit level and adjuster panels to
align the machine.
The ironer should be secured to the floor
using the screws and washers supplied in
the accessories pack.
,
It is essential to secure the machine to
the floor, as it could tip up if too much
laundry was placed on the out-tabling.
Attaching the out-tabling
The two support brackets for the out-tabling
on the inside of the end stands should each
be secured with 2, M 8 screws supplied.
The out-tabling is then placed on the
brackets and levelled so that the gap
between the feed-out edge of the roller and
the out tabling is as small as possible.
Secure the out-tabling with the wood screws
provided.
24

Electrical connection

The electrical connection may only be
carried out by a suitably qualified technician
in accordance with local and national safety
regulations.
The electrical components on the machine
conform to EN 60204-1.
The machine is supplied ex-works for AC 3N
50 Hz. See data plate for details.
Connection to the electrical supply must
be carried out in accordance with the
wiring diagram, installation diagram and
installation instructions supplied. These
are important to ensure the machine is
connected correctly.
The machine must be connected to a
permanent on-site electricity supply with a
suitable cable.
The wiring diagram and connection box are
located in the left hand side stand. The
mains cable terminals are located in the
connection box.
Warning:
Make sure that the exhaust fan is turning in
the correct direction (see directional arrow
on the fan). If it turns in the wrong direction,
2 phases have to be changed.
M.-Nr. 05 567 240 /03