Steel Wool Roller Padding; Cleaning And Care - Miele MM 50-175 Operating Instructions Manual

Steel wool roller padding

Removing the ironer cloth
Allow the heater plate to cool down before
removing the ironing cover (for cleaning or
replacing).
^ Raise the pick-off attachment upright.
^ Loosen the side ties of the ironing cloth.
^ Press s to switch the machine on.
^ Select the slowest speed setting.
Laundry
feed-in
^ Use the Forwards run Ü or Reverse run
Ä button to turn the roller until the end of
the ironing cover is visible at the feed-out
side of the roller.
^ Turn the end of the ironing cover to the
feed-in side.
^ Press the Reverse run Ä button and let
the cloth roll out.
M.-Nr. 05 567 240 /03
Cloth end
Cloth
leading
edge

Cleaning and care

Roller padding
Renewal of the steel wool roller padding
should only be carried out by a Miele
authorised service engineer.
,
To avoid the danger of injury
protective gloves should be worn whilst
renewing the roller padding.
Trim the steel wool covering to size.
Remove any particles of steel wool that fall
on the heater plate.
Fitting the roller cover
Do not wash a new roller cover before
use.
^ Raise the pick-off attachment upright.
^ Switch on the machine by pressing s.
^ Then turn the temperature selector
anti-clockwise to the lowest setting.
^ Press the Start h button.
^ When the ! heating indicator light has
gone out, press the Start h button again.
The heater plate moves up to the roller and
the roller starts turning.
^ Brush out the front edge of the cover with
a steel brush.
^ Place the roller cover on to the roller
following the direction of the arrow on the
steel wool padding. Run the cloth through
on the slowest setting.
Let the roller rotate for about 5 minutes. Then
cut off the overlapping strips and brush out
as you did with the beginning of the roller
cover. The ironing cloth must have no
creases in it.
Washing the roller cover
If possible, do not wash the roller cover if it
is only slightly discoloured. Slight yellowing
is normal. If the cover is heavily soiled, wash
it in a Cottons 95°C programme and replace
it while still damp.
19