Roller Padding; Removing The Ironing Cloth (Only For Steel-Wool Roller Covering); Fitting The Ironing Cloth (Only For Steel-Wool Roller Covering) - Miele PRI 210 Operating Instructions Manual

Roller padding

Before removing the roller cover for cleaning or replacing, switch off the flatwork ironer
and allow the heater plate to cool down.

Removing the ironing cloth (only for steel-wool roller covering)

 The ironing cloth on the PRI 217 with leaf-spring padding must only be removed or
replaced by the Miele Professional Service Department.
If the ironing cloth is removed without authorisation or the aid of the Miele Professional
Service Department, there is a risk of damaging the leaf-spring padding and the heater
plate.
Contact the Miele Professional Service Department. For rollers with leaf-spring padding,
the ironing cloth may only be removed or fitted by the Miele Professional Service
Department or by a trained authorised technician.
Before the ironing cloth can be removed from rollers with steel-wool padding, the
laundry pickers on the roller need to be fully retracted one after the other.
Switch on the flatwork ironer by pressing the  sensor.

Pull the finger guard up slightly.

Press the  sensor for more than 3 seconds.

The heater plate disengages and is locked into this position.
By repeatedly pressing the  sensor, incrementally rotate the roller in reverse (jogging

mode).
Take hold of the edge of the roller cover and lay it on the laundry infeed table.

With the roller in reverse, fully remove the roller cover.

After that, press the  sensor for longer than 3 seconds to deactivate the maintenance

position.
Wire wool residues may fall onto the laundry table whilst the roller cover is being removed.
These must be removed.

Fitting the ironing cloth (only for steel-wool roller covering)

Switch on the flatwork ironer by pressing the  sensor.

Pull the finger guard up slightly.

Select the lowest temperature () and the lowest roller speed ().

While operating the ironer normally, place the roller cover on the ironer parallel to the

roller and feed the roller cover over the roller.
The roller cover needs to be changed if there is a visible gap at the lower edge of the
heater plate and roller (laundry outfeed) due to prolonged use.
Recovering the roller with wire wool must only be carried out by Miele Professional
Service.
The diameter of a new or re-upholstered roller must not exceed the following dimensions
(including the roller cover).
Cleaning and care
37