Operation
Ironing
temperature
Setting the
temperature
16
Danger of burning on the hot edge of the heater plate.
Danger of burning on the edge of the hot heater plate! There is a
warning sticker on the heater plate housing to warn of the danger
of burning.
Avoid touching the edges of the heater plate.
Wait until the selected temperature has been reached.
The sensor begins to flash as soon as the minimum temperature
has been reached.
The flatwork ironer is ready for operation when the set temperature
is reached and the symbol no longer appears in the display.
Now press the flashing sensor to start up the flatwork ironer.
The ironer is now ready for use.
Ironing
Select the temperature according to the type of fabric.
Fabric
Symbol
Nylon/rayon
Silks/woollens
Cottons/linens
Temperature selection sensors
The ironer temperature can be set either via the temperature selection
sensors (//) or alternatively via the or – sensors.
When adjusting the machine from a higher ironing temperature to a
lower ironing temperature, the heater plate must cool down first. This
will turn off the heating of the ironer. The red display symbol will
indicate that the current ironing temperature is still too high. As soon
as the display symbol goes out, the selected temperature has
been reached.
Press the sensor on the control panel to call up the
temperature selection mode.
The sensor will be highlighted with a bar underneath.
Press one of the three temperature selection sensors (e.g.
temperature selection sensor ).
The button is highlighted with a bar underneath and the ironer is
heated up or cooled down to the selected temperature.
Temperature
Preset value
100–110 °C
110 °C
111–150 °C
125 °C
151–185 °C
180 °C