Using Accessories; Notes On The Use Of This Flatwork Ironer - Miele PRI 210 Operating Instructions Manual

Using accessories


Accessory parts may only be fitted when expressly approved by Miele. Using spare
parts or accessories from other manufacturers will invalidate the warranty, and Miele
cannot accept liability.

Coin operated ironers must be anchored to the floor by the supporting feet to prevent
the risk of the machine tipping.

Notes on the use of this flatwork ironer


Only responsible people over the age of 16 years who have been fully trained in the use
of the flatwork ironer should use the infeed table.

When working with the flatwork ironer, always wear close fitting clothes and keep long
hair tied back. Wide sleeves, apron straps, scarves and ties etc. could be taken in by the
roller.

Remove rings and bracelets before ironing.

Smooth out folds as far away from the infeed on the infeed table as possible. Feed
pillow cases and duvet covers into the ironer with the open end first. Do not take hold of
the corners from the inside. Do not take hold of straps or ties etc. from the inside of
garments.

Check daily that safety devices are correctly set. This flatwork ironer must only be used
if all safety features are functioning correctly. This way you will avoid the danger of burns,
squashed fingers and even loss of hands.

Before switching to reverse, make sure that nobody is endangered.
If other persons are being shown how to operate the flatwork ironer, they must be given
or made aware of these important safety instructions.
Pass these instructions on to any future users/owners of the flatwork ironer.
Warning and Safety instructions
7