Operation
FlexControl foot
switch
Stopping the roller
20
Activating the moveable foot switch stops the roller. This helps to
avoid input mistakes.
During ironing, press down the FlexControl foot switch with your
foot.
The roller will stop. The heater plate remains engaged.
Remove your foot from the foot switch to continue ironing.
When the foot switch is released, the roller starts to turn again
automatically. The ironing process can continue.
The foot switch can also be configured by Miele Professional
Service so that operating the foot switch ends Pause mode,
engages the heater plate and makes the roller start turning.
Stopping ironing
After ironing, let the roller run for approx. 10 minutes on the
minimum temperature to let the roller covering dry out.
Switch the flatwork ironer off by pressing the sensor.
The heater plate disengages and the fan runs for up to 10 minutes to
cool down the ironer. The sensor will flash during this time.
Switch off the on-site main switch.
Ironing with a coin-operated payment system
Press the sensor to switch on the flatwork ironer.
The symbol will flash in the display.
Insert the coin or token into the payment system.
The symbol will go out in the display.
Select the appropriate ironing temperature for the type of fabric.
Select the roller speed you want.
When the indicator light goes out, the set target temperature
has been reached and the ironer is ready to start ironing. This is
indicated by a buzzer sounding.
The ironing time purchased starts when the buzzer sounds.
Press the sensor to start the ironing process.
If ironing commences before the target temperature is reached, the
timer starts counting down when the sensor is pressed.
The heater plate engages and the roller starts to turn.
After the purchased ironing time has expired, the ironer emits an
audible signal to indicate that the run-on time has started. The preset
default run-on time is 1 minute.
You can now finish ironing the item that has been fed in.