Removal Of Ironed Laundry; Pausing Ironing; Standby Mode; Flexcontrol Foot Switch - Miele PRI 210 Operating Instructions Manual

Removal of ironed
laundry

Pausing ironing

Standby mode

Feed the item evenly into the machine.

Do not restrict ironing of smaller articles to any one part of the
roller.
Otherwise heat is transferred on one side only, and the roller cover
is worn down unevenly. If the laundry infeed continues to be on one
side only, this will be indicated by a buzzer and the red  symbol
or  symbol appearing in the display.
Make use of the whole roller width and distribute smaller items
evenly on the infeed table.
The picker springs on the laundry picker band separate the ironed
laundry from the roller. The laundry can then be removed from the
ironer.
 Risk of burning due to hot edges of the heater plate outfeed.
While the ironer is in use, the heater plate becomes very hot. Ironed
laundry may also be very hot when it emerges from the heater
plate.
Always take care when removing ironed laundry from the
appliance.
Do not touch the edges of the heater plate outfeed.
If a picker spring is loosened from its position, the ironer must be
switched off. The picker spring then needs to be moved by hand to
the original position of the laundry picker band.
 Risk of fire due to laundry self-ignition.
Hot laundry could self-ignite and cause a fire.
Allow the ironed laundry to cool down before packing or stacking it.
Press the  sensor to interrupt the ironing process and switch the

appliance to Pause mode.
In Pause mode, the roller stops and the heater plate disengages. The
heater of the ironer will initially remain switched on. During Pause
mode, the ironer remains ready for use.
Press the  sensor to start ironing again.

After an adjustable period of non-use, the ironer can switch to
standby mode. In standby mode, the roller comes to a standstill and
the heater plate is disengaged. During this process, the ironer heater
is switched off as well.
The ironer can be switched on again by pressing the  sensor.
Standby mode is deactivated by default. Standby mode can be
activated at service level by the Miele Professional Service
Department. The time at which the ironer will switch to standby
mode can be adjusted to a value between 1 and 30 minutes of non-
use.
Operation
19